Installation of the following certified device driver combination is described below.
Device Driver | Manufacturer |
---|---|
LTO drive(s) | IBM |
Medium Changer | DELL |
Installation Prerequisites
Ensure that the tape hardware is connected to the server. For SAS connections you must have point to point connections, for Fibre channel you can connect via a switch, however our recommendation is also point to point. The tape hardware must be powered on and in a ready state.
Tape Drive Drivers
Download the zipped device driver installation files from the link below to a folder on the C: drive of the Server.
» Download device driver - Windows 2008 R2 (Does not support LTO-7 Tape Drives)
» Download device driver - Windows 2012 R2
Unzip the files. Browse to the 'install_exclusive.exe' file and right-click on it. Select 'Run as administrator'. The program will launch a command line window and then display 'Program Successful'.
This completes the installation of an IBM device driver.
Note that if connections to the SAS or Fibre ports on the rear of the server are swapped, it may be necessary to reinstall the driver.
Library Drivers
This library uses a Dell device driver, which is available from Dell.
Supported Tape Formats
The following drive/cartridge combinations are supported by thesoftware with IBM LTO-4, LTO-5, LTO-6 and LTO-7 drives:
Cartridge | |||||||||
---|---|---|---|---|---|---|---|---|---|
Drive | Ultrium 3 R/W | Ultrium 4 R/W | Ultrium 4 WORM | Ultrium 5 R/W | Ultrium 5 WORM | Ultrium 6 R/W | Ultrium 6 WORM | Ultrium 7 R/W | Ultrium 7 WORM |
400 GB | 800 GB | 800 GB | 1500 GB | 1500 GB | 2500 GB | 2500 GB | 6000 GB | 6000 GB | |
LTO-4 | ✔ | ✔ | ✔ | X | X | X | X | X | X |
LTO-5 | read only | ✔ | ✔ | ✔ | ✔ | X | X | X | X |
LTO-6 | X | read only | read only | ✔ | ✔ | ✔ | ✔ | X | X |
LTO-7 | X | X | X | read only | read only | ✔ | ✔ | ✔ | ✔ |
www.xendata.com/support-xendata-server/ © Copyright XenData Limited. All rights reserved. |