IBM 3500 Libraries

Certified Device Drivers

Installation of the following certified device driver combination is described below.

Device Driver Manufacturer
LTO drive(s) IBM
Medium Changer IBM

Device Driver Installation for XenData Server Software

Installation Prerequisites  XenData Hardware

Ensure that the tape hardware is connected to the server. For SAS connections you must have point to point connections, for Fibre channel you can connect via a switch, however our recommendation is also point to point. The tape hardware must be powered on and in a ready state.

Tape Drive Drivers  XenData Hardware

Download the zipped device driver installation files from the link below to a folder on the C: drive of the Server.

» Download device driver - Windows 2008 R2 (Does not support LTO-7 Tape Drives)

» Download device driver - Windows 2012 R2

Unzip the files. Browse to the 'install_exclusive.exe' file and right-click on it. Select 'Run as administrator'. The program will launch a command line window and then display 'Program Successful'.

This completes the installation of an IBM device driver.

Note that if connections to the SAS or Fibre ports on the rear of the server are swapped, it may be necessary to reinstall the driver.

Library Drivers  XenData Hardware

By running the Install Exclusive program during the above 'Tape Drive driver' section, the IBM driver will have been automatcially installed for the Library.

Supported Tape Formats  XenData Hardware

The following drive/cartridge combinations are supported by thesoftware with IBM LTO-4, LTO-5, LTO-6 and LTO-7 drives:

  Cartridge                
Drive Ultrium 3 R/W Ultrium 4 R/W Ultrium 4 WORM Ultrium 5 R/W Ultrium 5 WORM Ultrium 6 R/W Ultrium 6 WORM Ultrium 7 R/W Ultrium 7 WORM
  400 GB 800 GB 800 GB 1500 GB 1500 GB 2500 GB 2500 GB 6000 GB 6000 GB
LTO-4 X X X X X X
LTO-5 read only X X X X
LTO-6 X read only read only X X
LTO-7 X X X read only read only